IGN-4 Four Tower Wasted Spark Coil

4.8 (407) · $ 19.00 · In stock

The IGN-4 four tower ignition coil is an affordable option for a hot distributorless ignition! Similar to our IGN-1A coil, but this unit has four outputs that fire in wasted spark and does not have a built in ignitor.
The IGN-4 four tower ignition coil is an affordable option for a hot distributor-less ignition! Similar to our IGN-1A coil, but this unit has four outputs that fire in wasted spark and does not have a built in ignitor. If used with our BIP373 ignition modules we recommend 3.0-3.5 ms dwell though you should fine tune this for your application. Perfect for a four cylinder engine, or use two for a V8. Uses standard HEI type spark plug boots. The center pin on the connector is a 12 volt supply. Each of the two side pins connects to a coil driver such as a BIP373 or QuadSpark and fires the two posts on the same side as the connector pin. It is not necessary to ground the coil mounts. The coil measures approximately 4 7/8 wide, 3 1/4 across, and 2 5/8 tall. Electrical Specifications: Primary Resistance: 0.5 Ω +/- 10% Primary Inductance: 4.8 mH +/- 15% Secondary Resistance: 8.5 kΩ +/- 20% Secondary Inductance: 22.5 H +/- 20% Output Voltage: 41 kV +/- 10% Output Energy: 118 mJ +/- 7% Peak Secondary Current: 100 mA +/- 7% Arc Duration: 3.2 mS +/- 10% Turns Ratio 71:1 Maximum Battery Voltage: 17 Volts Standard Dwell: 3.0 mS These are very solid, robust coils that will do well for you if dwell is set up correctly. However, they can be killed by excessive dwell or duty cycle. As they are race coils, the manufacturer does not provide a warranty. Connector sold separately.